Troubleshooting Guide - Bauknecht DTLG 9010 Benutzerhandbuch

TROUBLESHOOTING GUIDE

The hood does not work
Make sure:
• There is not a power failure.
• A speed has actually been selected.
• The front panel is correctly hooked.
• The 9-pin connection is properly inserted. (Figure 1)
• The red reset button on the electrical system box is pressed. (Figure 2)
• In the 9-pin connection, make sure the wires are properly inserted in the connector. (When
connecting, pressing too hard could bend the contacts). (Figure 3)
The hood does not extract sufficiently
Make sure:
• The selected speed is sufficient for the quantity of fumes and steam present.
• There is enough ventilation to allow an air inlet.
• The carbon filter is not worn (Filter version hood).
• The exhaust air outlet pipe is free of obstructions.
• The extraction unit non-return valves are free to rotate. (Figure 4)
The hood stops during operation
Make sure:
• There is not a power failure.
• The differential thermal-magnetic switch (safety cutout) has not tripped.
The lamp does not work
• Check if the lamp needs replacing.
• Make sure the lamp is correctly fitted.
GB14
Fig. 1
Fig. 2
Fig. 3
Fig. 4