Sharp AR-FR4 U Bedienungsanleitung Seite 6

2-(1) POWER UP AUTO CLEAR
This program automatically clears all data stored in the unit when the main switch is
turned on. The factory setting is no checkmark.
To turn on "POWER UP AUTO CLEAR", select the checkbox
deselect the checkbox
NOTES
G G G G
If the optional fax expansion kit is installed
Fax data received during the night that has not been printed will not be cleared.
G G G G
If you wish to cancel after data clearing has begun
See "Clear screen 2" in "CLEAR ALL MEMORY" on page 3 of this manual.
2-(2) NUMBER OF TIMES POWER UP AUTO CLEAR PROGRAM IS
REPEATED
This program is used to enhance the security function. The repeat count for "POWER
UP AUTO CLEAR" can be set to any number from 1 to 7. The factory setting is 1.
Touch the [NUMBER OF TIMES POWER UP AUTO CLEAR PROGRAM IS
REPEATED] key, and set the desired number of times with the
When finished, touch the [OK] key.
(See "About the repeat count setting" on page 5 of this manual.)
NOTE
This key is only enabled when the "POWER UP AUTO CLEAR" checkbox is selected.
3 NUMBER OF TIMES AUTO CLEAR AT JOB END PROGRAM IS
REPEATED
This program is used to enhance the security function. The number of times of auto clear
after each job is printed can be set to 1 to 7. The factory setting is 1.
Touch the [NUMBER OF TIMES AUTO CLEAR AT JOB END PROGRAM IS
REPEATED] key, and set the desired number of times with the
When finished, touch the [OK] key.
(See "About the repeat count setting" on page 5 of this manual.)
.
4
. To turn it off,
or key.
or key.