About The Security Function - Sharp AR-FR4 U Bedienungsanleitung

About the Security Function

I I I I SECURITY SETTINGS
1-(1) CLEAR ALL MEMORY
Use this setting when you wish to manually clear data stored in the unit's memory
and on the hard disk.
NOTE
We recommend that you execute this program before turning off the power.
Touch the [CLEAR ALL MEMORY] key. The following screen appears to confirm
your selection.
[Clear screen 1]
CLEAR ALL MEMORY?
(RESERVED JOB DATA WILL BE CLEARED.)
[Clear screen 2]
CLEARING ALL MEMORY. AUTO REBOOT IS
IMPLEMENTED AFTER CLEARING.
0 % 50
NOTE
If you wish to cancel after data clearing has begun
Touch the [CANCEL] key. When the [CANCEL] key is touched, the key operator code
entry screen appears. Enter your key operator code with the numeric keys. Note that
data that has already been cleared at the time you enter your 5-digit key operator code
will not be restored. Data already cleared will be lost.
1-(2) NUMBER OF TIMES CLEAR ALL MEMORY PROGRAM IS
REPEATED
This program is used to enhance the security function. The repeat count for "CLEAR
ALL MEMORY" can be set to any number from 1 to 7. The factory setting is 1.
Touch the [NUMBER OF TIMES CLEAR ALL MEMORY PROGRAM IS REPEATED]
key, and set the desired number of times with the
When finished, touch the [OK] key.
(See "About the repeat count setting" on page 5 of this manual.)
NO YES
CANCEL
% 100 %
3
G
To return to
SETTINGS" screen, touch the [NO] key.
G
To clear all memory, press the [YES]
key. "PLEASE WAIT." appears, and
then the following screen is displayed.
G When the data has been cleared, the
power briefly turns
automatically turns on again.
or key.
the "SECURITY
off and then