JVC WR-MG77U Vorgehenweise Seite 7

F
Upon removing the camera, close the marine case again while paying
attention not to allow water droplets enter the case, followed by
tightening all the buckles.
G
Final salt removal
Submerge the marine case in fresh water for at least 1 hour to
remove salt.
• Shaking the case body in the upward and downward directions and rinsing it
helps to remove salt more effectively.
• Make sure the marine case is fully submerged in the fresh water.
H
Remove the marine case and wipe off water droplets on the case
surface using a dry cloth. Then open the buckles to allow the inside
and outside of the case to dry thoroughly.
Memo
Memo
• Temperature, humidity, water temperature, salinity and other conditions
vary according to the environment of use.
Note Note
When the Start/Stop button does not function
• The Start/Stop button may be disabled when the zoom lever is fixed at the
T or W end.
• In this case, restore the zoom lever to the center position.
To prevent the zoom lever from being jammed at a position
• Attachment of salt or sand to the zoom lever may cause it to jam, and
therefore cause the Start/Stop button to stop functioning.
• After use, submerge it in fresh water for at least 1 hour to remove any salt
deposit. Move the lever and button in the water to wash off salt deposited
in the spaces in between.
7