Werbung
Verfügbare Sprachen
Verfügbare Sprachen
After shooting (sea salt removal)
Make sure to perform maintenance on the marine case.
Salt crystal or dirt will accumulate inside the marine case if maintenance is not
performed, and this may cause water leakage.
A
Prepare a container that contains fresh water that is five times more
than the volume of the marine case.
• If only small containers are available, pour in fresh water that is equivalent to at
least five times the volume of the marine case over a few times, followed by
performing salt removal in
Example: Container with volume
equivalent to 1 marine case
• The container must be big enough to allow the marine case to submerge fully.
• Perform salt removal for the grip as well.
B
After diving, submerge the marine case in fresh water for 30 minutes
without removing the camera.
C
Temporary salt removal
Shake the marine case in the upward, downward, left and right
directions for at least 10 times, followed by rinsing it.
• If you do not need to take out the camera immediately, proceed to
actual salt removal.
D
Remove the marine case and wipe off water droplets on the case
surface using a dry cloth.
E
Face the front glass of the marine case upwards, and open the
buckles to remove the camera, while paying attention not to let water
droplets at the O-ring or buckles enter the case.
6
G
.
Front glass
Pour in water over 5 times
G
for the
Werbung
