JVC KV-M70 Bedienungsanleitung Seite 6

6
Introduction to the Roles of the System Components (continued)
KV-M70 display unit
Used to display the
configuration screen for
changing the input source.
Used to turn the power
source ON and OFF
STAND BY (R), ON (G)
When the power is off ... red
When the power is on ... green
Remote sensor
Speaker
(on the back side)
Used to display, select and determine the ASPECT (display size).
Used to display, select and determine the
various adjustments (screen, menu).
/ MODE ASPECT
MOBILE COLOR MONITOR SYSTEM
Screw holes are provided for attaching the monitor
stand (on the bottom side).
(1/4 inch unify screw, maximum length of 4.5 mm)
Normally:
Used to control the volume level of
built-in speaker.
When setting various menus:
Menu selection
When setting various adjustment modes:
Adjustment and switching
MENU
13, 14
Dimmer sensor
This sensor automatically adjusts the screen brightness.
(When Auto Mode is set for the Dimmer Setting, the
screen brightness is automatically adjusted to one of 12
levels to suit the surrounding brightness.)
KV-M70
Terminal for connecting
the cable from the
controller unit (on the
right side)