Technical Data - Scheppach Dp60 Originalbetriebsanleitung

e. Make sure the accessory is rotating before
feeding into the workpiece.
Otherwise the accessory may become jammed in
the workpiece causing unexpected movement of
the workpiece and personal injury.
f. When the accessory is jammed, stop applying
downward pressure and switch off the tool. In-
vestigate and take corrective actions to elimi-
nate the cause of the jam.
Jamming can cause unexpected movement of the
workpiece and personal injury.
g. Avoid generating long chips by regularly inter-
rupting downward pressure.
Sharp metal chips may cause entanglement and
personal injuries.
h. Never remove chips from the drilling area
while the tool is running. To remove chips,
move the accessory away from the workpiece,
switch off the tool and wait for the accessory
to stop moving. Use tools such as a brush or
hook to remove chips.
Contact with rotating parts or chips may result in
personal injury.
Accessories with speed ratings must be rated
i.
at least equal to the maximum speed marked
on the power tool.
Accessories running faster than their rated speed
can break and fly apart.
Attention: Laser radiation
Do not stare into the beam
Class 2 laser
Protect yourself and you environment from acci-
dents using suitable precautionary measures!
• Do not look directly into the laser beam with unpro-
tected eyes.
• Never look into the path of the beam.
• Never point the laser beam towards reflecting sur-
faces and persons or animals. Even a laser beam
with a low output can cause damage to the eyes.
• Caution - methods other than those specified here
can result in dangerous radiation exposure.
• Never open the laser module. Unexpected exposure
to the beam can occur.
• The laser may not be replaced with a different type
of laser.
• Repairs of the laser may only be carried out by the
laser manufacturer or an authorised representative.
Remaining hazards
Even if you use this electric power tool in accord-
ance with instructions, certain residual risks can-
not be eliminated. The following hazards may
arise in connection with the equipment's con-
struction and layout:
• Lung damage if suitable dust protection mask is not
worn.
• Hearing damage if suitable hearing protection is not
worn.
• Damage to health resulting from hand/arm vibration
if the device is used over an extended period of time
or if it is not properly operated and maintained.
m Warning!
This electric tool generates an electromagnetic field
during operation. This field can impair active or passive
medical implants under certain conditions. In order to
prevent the risk of serious or deadly injuries, we recom-
mend that persons with medical implants consult with
their physician and the manufacturer of the medical im-
plant prior to operating the electric tool.

6. Technical data

AC motor........................................... 220 - 240 V~ 50 Hz
Nominal power S1..............................................710 Watt
Operating mode S2..................................... 5min* 900W
Idle speed n
- 1st gear .................................................170 - 880 rpm
- 2nd gear...............................................490 - 2600 rpm
Max. drilling speed
- Steel.........................................................170 - 880 rpm
- Wood.....................................................490 - 2600 rpm
Drill chuck clamping range............................1.5 - 13 mm
Max. drill stroke...................................................100 mm
Size of base plate.................................... 350 x 300 mm
Weight ................................................................... 9.4 kg
Protection class ..................................................... II /
Laser class.....................................................................2
Laser wavelength................................................650 nm
Laser power ........................................................< 1 mW
Subject to technical changes!
www.scheppach.com
0
GB | 27