Troubleshooting; Technical Specifications - Kärcher WD 7.2 serie Originalbetriebsanleitung

Clean flat fold filter
Illustration
I
1
 For appliances without filter clean-
ing:
Release and open the filter flap. Re-
move the frame and filter and knock the
dirt out of the filter. Clean the filter under
running water if necessary. Do not rub
or brush the filter dry.
Let it dry completely prior to installation.
Illustration
I
2
 After that, insert the filter first and then
the frame.
 For appliances with ExPress filter
cleaning: Use the filter cleaning (see
Chapter "ExPress filter cleaning").
Note: If the suction performance is still
not satisfactory, in spite of the cleaning,
separate the suction hose from the
pipes, hold the opening of the suction
hose shut/close it and activate the filter
cleaning button three more times with
the suction hose held shut.

Troubleshooting

Mains cable retraction does not
 The mains cable is probably dirty, clean
the mains cable.
Water is leaking
 Turn off the appliance immediately.
Illustration
J
1
 Clean the floater system.
Remove the appliance head, unscrew
the floater basket (A) in the direction of
the arrow and remove it. Remove the
floater (B) and clean both under flowing
water.
To install, first insert the floater, then
add the floater basket and lock it.
Decreasing cleaning power
If the suction power becomes less, check
the following points:
18
function
 Accessories, suction hose or suction
tubes are clogged, please remove the
obstruction.
 Flat fold filter contaminated:
For appliances without ExPress filter
cleaning: Remove the flat fold filter and
clean it (see chapter "Cleaning the flat
fold filter").
For appliances with ExPress filter
cleaning: Activate the filter cleaning
button 3 times; if necessary, repeat the
cleaning process with the suction hose
closed (held shut) (see Chapter "Clean-
ing flat fold filter").
Clean the filter under running water if
necessary.
 Replace damaged flat folded filter.
 Filter bag is full: Insert new filter bag
(Order No. refer to spare parts list at the
end of this manual).
Caution
Please do not dispose of the filter bag intake!

Technical specifications

The specifications are listed on the flaps. In
the following, you will find the explanation
of the symbols used.
Voltage
Output P
Output P
Max. connection output of appli-
ance socket
Mains fuse (slow-blow)
Container capacity
Water intake with handle
Water intake with floor nozzle
Power cord
Sound pressure level (EN
60704-2-1)
Weight (without accessories)
Subject to technical modifications!
– 12
EN
nom
max