Storage; Maintenance And Care; Troubleshooting - Kärcher 1.528-Serie Bedienungsanleitung

Storage

CAUTION
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.

Maintenance and care

DANGER
Turn the appliance off and disconnect the
mains plug or remove the batteries before
carrying out any tasks on the machine.
Clean main filter basket
 Main filter basket (washable), clean it
under running water if necessary.
ATTENTION
Risk of damage! Never insert the main filter
basket while wet.
Replace motor protection filter
 Release and remove the suction head.
 Push the grids of the motor protection
filter down, turn and remove.
 Remove the motor protection filter.
 Insert the new motor protection filter.
 Insert the grid of the motor protection fil-
ter and lock it into place.
 Insert and lock the suction head.

Troubleshooting

DANGER
Turn the appliance off and disconnect the
mains plug or remove the batteries before
carrying out any tasks on the machine.
The appliance shuts off during the
operation
– Motor thermal protector has responded.
 Replace the fleece filter bag or paper fil-
ter bag (option).
 Replace motor protection filter.
 Check all parts for plugging.
Switching back on after the motor turbine
has cooled off, after approx. 30 to 40 min-
utes.
Suction capacity decreases
 Remove choking of suction nozzle, suc-
tion tube or suction hose.
 Replace the fleece filter bag or paper fil-
ter bag (option).
 Clean the main filter basket under run-
ning water.
 Insert/lock the suction head correctly.
 Replace defective suction hose.
 Replace motor protection filter.
Dust comes out while vacuuming
 Replace the fleece filter bag or paper fil-
ter bag (option).
 Check the fleece filter bag or paper filter
bag (option).
 Insert/lock the suction head correctly.
 Insert undamaged main filter basket.
 Reinsert motor protection filter correct-
ly.
Indicator lamp for battery on the
appliance is blinking
– Battery empty
 Charge the battery.
– No battery is inserted
 Insert the battery.
Appliance is not running
 Turn on the appliance.
In battery mode
– PCB overheated
 Mains operations are possible.
Note: The appliance can be operated in
battery mode after the PCB has cooled
down.
– Batteries empty
 Charge the batteries.
– No battery is inserted
 Insert the battery.
In mains operation
 Check the receptacle and the fuse of
the power supply.
 Check the power cable and the power
plug of the device.
– 4
EN 13