Setting The Time And Date Manually - ADE WS 1502 Bedienungsanleitung

‚ You can start the receiving process again manually,
see "Starting signal reception manually", or
‚ Wait until the base station automatically switches
to receiving mode again at a later point in time. The
reception is usually better at night.
‚ If reception is not possible at your location, you can
set the time and date manually, see next chapter.

Setting the time and date manually

If there is more than approx. 20 seconds between
two pushes of a button, the setting process
automatically ends and you will have to repeat it.
1. Press and hold the MODE button until the indicator for
the 12- and 24-hour time format blinks on the display.
2. Using the + and - buttons, set the desired time format
("12 hr" or "24 hr").
3. Press MODE to save the setting. The temperature unit
blinks on the display.
4. Proceed as previously described.
5. Press MODE each time to save the settings.
6. Press the + or - button to set the desired value.
7. Carry out the following settings:
− Temperature unit
− Air pressure unit
− Time zone in which you are located (for Germany,
choose 00)
Weather Station with Wireless Outdoor Sensor WS 1502/1503
57