Night Vision; Settings; Technical Data - Beurer Janosch JBY 101 Gebrauchsanweisung

Lullabies
• Press the button to start playing the first song. The LED
• Press the button to go to the next song or switch to repeat mode, so that songs are played con-
tinuously. Your selection is displayed on the monitor.
• Press the button to stop the music from playing. The LED

Night vision

To switch night vision on, press the

8 Settings

You can select the following settings on your monitor:
Press the button or
The camera is equipped with nine infrared LEDs, so that a good picture can be transmitted even
in the dark. The built-in photo sensor detects when the light surrounding the camera is too dim. In
this case, the LEDs are automatically activated.
Turn the volume control up or down in order to increase or reduce the receiver volume on the
monitor.
The sound intensity is also pictured using an LED light band so that the device can also be used
by the hard of hearing or the deaf.

9 Technical data

• DECT technology
• 2.4 GHz frequency
• Digital receiver
• 2.36" TFT display
• Infrared technology (automatic switching of camera at twilight or in darkness)
• ECO mode
• Dimensions: Camera: Ø 8.9 cm x 11 cm foot: Ø 7.5 cm; monitor: 14 x 6.5 x 4 cm
• Weight: Camera 154 g, monitor + battery 147 g
• 150 m range with a clear view
Operation
Battery life (dependent on batteries used)
Rechargeable battery life (dependent on
battery condition, ambient temperature,
method and frequency of charging, etc.)
14
button on the camera.
on the display to make the display lighter or darker in five stages.
Camera: 4 batteries 1.5 V, type AAA or
Monitor: Lithium-ion battery (1 x 3.7 V 1050 mAh) or
Camera: approx. 5 hours in daylight mode
Monitor: approx. 8 hours in ECO mode
glows red.
goes out.
power supply unit (6 V DC/800 mA/10 W)
power supply unit (6 V DC/800 mA/10 W)
approx. 3 hours in infrared mode
approx. 1.5 hours in infrared mode with night
vision
approx. 6 hours in LCD mode