Installation Warnings - Telefunken Tfeks88X10A++ Bedienungsanleitung

and user maintenance, shall not be made by children
without supervision.
• If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similar
qualied persons in order to avoid a hazard.
• This appliance is not intended for use at altitudes
exceeding 2000 m.

1.2. Installation Warnings

Before starting to use your fridge freezer,
you should pay attention to the following
points:
• The operating voltage for your fridge
freezer is 220-240 V at 50Hz.
• The plug must be accessible after
installation.
• Your fridge freezer may have a smell
when it is operated for the rst time. This
is normal and the smell will fade away
when your fridge freezer starts to cool.
• Before connecting your fridge freezer,
ensure that the information on the data
plate (voltage and connected load)
matches that of the mains electricity
supply. If in doubt, consult a qualied
electrician.
• Insert the plug into a socket with an
efcient ground connection. If the socket
has no ground contact or the plug
does not match, we recommend that
you consult a qualied electrician for
assistance.
• The appliance must be connected with
a properly installed fused socket. Power
supply (AC) and voltage at the operating
point must match with the details on
the name plate of the appliance (name
plate is located on the inside left of the
appliance).
• We do not accept responsibility for any
damages that occur due to ungrounded
usage.
• Place your fridge freezer where it will not
be exposed to direct sunlight.
• Your fridge freezer should never be used
outdoors or exposed to rain.
• Your appliance should be at least 50 cm
away from stoves, gas ovens and heater
cores, and at least 5 cm away from
electrical ovens.
• When your fridge freezer is placed next
to a deep freezer, there should be at least
2 cm between them to prevent humidity
forming on the outer surface.
• Do not place heavy items on the
appliance.
• Clean the appliance thoroughly, especially
the interior, before use (see Cleaning and
Maintenance).
• The installation procedure into the kitchen
unit is given in the installation manual.
This product is intended to be used in
proper kitchen units only.
• Use the adjustable front legs to make
sure your appliance is level and stable.
You can adjust the legs by turning them
in either direction. This should be done
before placing food in the fridge freezer.
• Before using your fridge freezer, wipe all
parts with a solution of warm water and
a teaspoon of sodium bicarbonate, then
rinse with clean water and dry.
Place all parts in the fridge after cleaning.
• Install the plastic distance guide (the part
with black vanes at the rear) by turning it
90° (as shown in the gure) to prevent the
condenser from touching the wall.
EN - 24