Herunterladen Diese Seite drucken

Flott S 25 U Bedienungsanleitung Seite 7

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

4.0 Transport
ATTENTION! Always check delivery for completeness and damage!
The carrier (forwarder or railway) is to be informed immediately in case of transport damages.
(s. yellow leaflet)
5.0 Setting up the machine
The drill should be set up on a solid base and aligned using a spirit level. If the machine is to be bolted to the base,
ensure that the base plate does not warp in the process. Use of vibration damping elements is recommended.
6.0 Installation
The machine has been installed ready for use. Please check whether type of current, current voltage and fusing
agree with the prescribed values. There must be a protective ground terminal. Mains fusing 16 A.
Attention! Take notice of the right rotation (right-hand) of spindle.
7.0 Commissioning
The parts with rust-inhibiting coating should be cleaned carefully. The column should then be lubricated. The table
should be moved several times since condensation may have formed in the table guide.
8.0 Operating and indication elements
(max. equipment)
1. main switch
2. pole switch or combined pole/reverse switch
3. emergency off switch
4. selector drilling/tapping ( optional)
9.0 Operating
All machines are switched on and off using the main switch. Ensure that the emergency off switch is released. If
available, use the pole switch to select the speed range and the reverse switch to select between speed range 1
r.h. and l.h. turning direction. The selection switch drilling/tapping selects the operating mode.
10.0 Speed change
All available speeds are choosen according to the symbols on the front plate using two levers on the l.h. side of the
Machine head. Do not change speed while spindle is running. If the speed changing is not easy to operate, turn
spindle manually.
11.0 Drilling depth indication
machines without digital drilling depth display use a scale to indicate drilling depth.
12.0 Adjusting the drilling depth
12.1The manual feed is being made using the r.h. star wheel.
12.2 If the machine is equipped with automatic feed (type M or ME), the feed speed is selected using a lever on the
feed gear. For feed selection the spindle must be run without load.
Automatic feed
The feed adjustment is made using the wheel on the front of the spindle housing.
Attention: the feed cannot be switched from highest speed direct to lowest speed, all steps (speeds) between must
be activated. For feed selection the spindle must be run without load.
Drilling depth is adjusted using the drilling depth end stop and the scale on the front. The activation of the feed is
made by using the switch wheel, moved first to the right and then moved down, as shown on the diagram. After
reaching the drilling depth the spindle motor is switched off and the spindle moves upwards to zero position.
Attention: the fine feed must be deactivated before the feed is engaged.
286076 D/E
E
6

Werbung

loading