Hendi 860083 Gebrauchsanweisung Seite 6

To use
1. Fill the water pan with water
up to the MAX (min. up to the
MIN) mark
4. Once the soup kettle is
switched on. Its default SET
TEMPERATURE is at 80°C
95˚C
65˚C
EN NL
Overheating Protection
95˚C
65˚C
95˚C
65˚C
6
2. Fill the soup pot with soup
not over the MAX mark
5. You can adjust the SET TEM-
PERATURE by pressing the UP
and DOWN buttons at the left
side of the control panel
95˚C
65˚C
If the water level in the water pot is too low, the red
indication lamp will blink and the buzzer sounds.
You should fill the water pan with water no further
than to the MAX mark and switch off the soup kettle.
Then you need to wait for a while until the tempera-
ture of the soup kettle has dropped before switching
on the soup kettle again.
3. Connect the soup kettle to
power and press the ON/OFF
switch
95˚C
65˚C
6. The soup kettle is in opera-
tion. Before the soup reaches
the SET TEMPERATURE, both
the SET TEMPERATURE and the
ACTUAL TEMPERATURE will be
alternately displayed
95˚C
65˚C