Hendi 860083 Gebrauchsanweisung Seite 4

Hendi Soup kettle Eco 860502
Hendi Soup kettle 860083
*Indoor use, ambient temperature of 25 °C, lid closed and water pan filled to at least the minimum
water level mark.
Preparation and how to use
• Check to make sure the appliance is undamaged.
In case of any damage, contact your supplier im-
mediately and do NOT use the appliance.
• Remove all the packing material and protection
film (if applicable).
• Clean the appliance with luke-warm water and a
soft cloth.
Important
• Always ensure that there is sufficient water in the inner pot. Check this regularly, also during use.
Maintenance advice
• Always remove the plug from the socket before
cleaning.
• If used intensively, regularly remove lime scale
from the bottom of the water tank
EN
• Never immerse the appliance in water or any other
cleaning fluid
• Clean the appliance with a damp cloth
Faults
Fault
Appliance does not work
Appliance does not reach the
set temperature
Buzzer alarms
4
Consumption per hour
0,125 kWh
0,160 kWh
• Place the appliance on a level and steady surface,
unless mentioned otherwise.
• Make sure there is enough clearance around the
appliance for ventilation purposes.
• Position the appliance in such a way that the plug
is accessible at all times.
• Never use aggressive, corrosive cleaning agents
or abrasives. Do not use any sharp or pointed ob-
jects. Do not use petrol or solvents! Clean with a
damp cloth and detergent if necessary. Do not use
abrasive materials.
• Avoid water contact with the electrical compo-
nents as much as possible.
Possible cause
No power at the socket
The plug is not plugged (cor-
rectly) into the power point
Heating element faulty
Control unit faulty
Heating element fuse faulty
Heating element overheat
Possible solution
Check the fuse
Check the plug
Contact the supplier
Contact the supplier
Contact the supplier
First, check if water level is
below the "MIN" mark.
If alarm is still ON after cool
down, contact the supplier for
aftersales service