Start-Up; Installation Instructions - HomeMatic Multi IO Box Installations- Und Bedienungsanleitung

Start-up

Make sure that no electricity or similar lines run in
the wall at this location!
• Use a pen to mark the positions of the four bore
holes on the wall (see fig. 2).
• Use an appropriate drill to make the 6 mm holes
as illustrated.
• Use the screws and plugs supplied to fasten the
Multi IO Box (see fig. 2).
6 Start-up
6.1

Installation instructions

Please read this entire section before starting to
install the device.
Please note! Only to be installed by persons
with the relevant electro-technical knowledge
and experience!*
Incorrect installation can put
• your own life at risk;
• and the lives of other users of the electrical system.
Incorrect installation also means that you are running the
risk of serious damage to property, e.g. because of a fire.
You may be personally liable in the event of injuries or
damage to property.
46