Last Function Memory; Initialization Of The Microprocessor - Denon ADV-M71 Bedienungsanleitung

ENGLISH
21

LAST FUNCTION MEMORY

• This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately before the
power is switched off.
This function eliminates the need to perform complicated resettings when the power is switched on.
• The unit is also equipped with a back-up memory. This function provides memory storage when the power switch is off and with the power
cord disconnected.
22

INITIALIZATION OF THE MICROPROCESSOR

When the indication of the display is not normal or when the operation of the unit does not shows the reasonable result, the initialization of the
microprocessor is required by the following procedure.
1 Press the power button to set the
standby mode, then unplug the set's
power cord from the wall power outlet.
2 Hold the following PLAY/PAUSE (
button after 30 second, and plug the AC cord into the outlet.
3 Check that the entire display is flashing with an interval of
about 1 second, and release your fingers from the 2 buttons
and the microprocessor will be initialized.
112
ON / STANDBY
Red
1 / 3 ) button and STOP ( 2 )
B
DVD SURROUND RECEIVER ADV-M71
ON / STANDBY
1
NOTES:
• If step 3 does not work, start over from step 1.
• If the microprocessor is reset, all the buttons and the setup
settings are reset to the factory default values.
2 2
SURROUND / SELECT
PUSH - PARAM.
- +
BAND
MENU / SET
TONE / SDB VOLUME
FUNCTION
PHONES