Electrical Connection; Device Elements; Start Up; Operation - Kärcher IVR-L 100/24-2 Originalbetriebsanleitung

Electrical connection

The appliance may only be connected to an
electric supply that has been installed by an
electrician in accordance with IEC 60364.
For connection values, see technical data
and type plate.
You are not allowed to use an extension cable.
DANGER
Risk of electric shock. Electrical connecting
cables must not be damaged through being
driven over, crushed, pulled or the like. Pro-
tect the power cord from heat, oil, and
sharp edges.
Check the mains cables of the machine
each time before using the machine to see
that it is not damaged. Never operate a ma-
chine with damaged cables. Get the dam-
aged cables replaced by an electrician.
CAUTION
The highest allowed net impedance at the
electrical connection point (refer to techni-
cal data) is not to be exceeded.
In case of any uncertainty regarding the
present net impedance at your connection
point, please contact your local power sup-
ply company.

Device elements

Illustration on the inside of the front
cover
1 Guiding rolls with fixed position brake
2 Unlocking lever
3 Standpipe for drum pump
4 Drain hose
5 Push handle
6 Liquid reservoir
7 Deflector plate
8 Power cord
9 Suction head
10 ON/OFF switch
11 Suction hose connection
12 Lock
13 Drum pump
14 On/Off switch drum pump
15 Adjustment of the delivery rate of the
drum pump (+/- button)
16 Disposal hose drum pump
17 Support disposal hose
18 Accessories compartment
Illustration on the inside of the front
cover
 Bring the appliance to working position
- secure it, if required, with parking
brakes.
 Ensure that the suction head has been
fitted properly.
Illustration
 Insert the suction hose into the suction
hose connection.
 Attach the desired accessories to the
suction hose.
Illustration on the inside of the front
cover
 Insert the mains plug into the socket.
Illustration
 Turning on the Appliance
Note: The switch has several switching
stages:
0 Device is switched off
1 Motor 1 switched on
2 Motor 1 and 2 switched on
Always operate the device in stage 2.
ATTENTION
Risk of damage! Always switch the switch-
ing stages quickly in order to prevent dam-
age of the drive motor.
 Start suction process.
Note: When vacuuming up fluids, only im-
merse the accessories half way in order to
deliver sufficient air.
– 3
EN

Start up

Operation

13