Decoderwerk 20102 Benutzerhandbuch Seite 24

Commissioning
Connecting uncoupling tracks
The decoder has an output with 2 connections.
◆
Uncoupling tracks
◆
connection cables that must be soldered
directly to the decoder.
To solder the connection cables, you should
◆
remove the decoder from the track, as the
heat generated can damage the mounting pin
of the track.
Connecting other consumers
Alternatively, other loads can also be
◆
connected and switched at the outputs.
To do this, the supply cable of the
◆
consumer must be soldered to the two
solder connections.
Connect outputs
usually have two
Performance
9-24V direct voltage
◆
2A current
◆
Take your time
The uncoupling track remains activated as long as
the button on the control panel is pressed.
The polarity must be observed when
◆
connecting the consumer.
If the load is to be switched continuously,
◆
the switching time must be changed to
continuous operation.
8