Technics SUG700E Bedienungsanleitung Seite 29

Switching this unit and the
connected device
• If you point the remote control at this unit
and press [AMP ] when this unit and the
connected device are in standby mode, this
unit and the device of the selected input source
which is set with "System Control" will be
turned on simultaneously.
• If you point the remote control at this unit
and press [AMP ] when this unit and the
connected device are turned on, this unit and
the connected device will enter standby mode.
• You can also switch this unit and the connected
device by pressing the standby/on button on
this unit.
Switching this unit's input source
automatically
When you perform an operation such as
playback on the connected device, the input
source of this unit will be automatically switched
to the source which is set with "System Control".
29
Settings
(29)