Technics SUG700E Bedienungsanleitung Seite 19

Analogue audio cable (not supplied)
Using analogue audio cable
1 Disconnect the AC mains lead.
2 Connect this unit and a Blu-ray Disc
player, etc.
3 Connect the AC mains lead to this unit.
( 15)
4 Press [AMP ] to turn this unit on.
5 Press [>INPUT<] repeatedly to select
"LINE1" or "LINE2".
• You can also select the input source by
turning the input selector knob on the unit.
• Set to "LINE2" (see below) when "MAIN IN"
is displayed as input source of this unit.
6 Start playback on the connected
device.
When connecting to "LINE2"
Analogue audio input terminals (LINE2 IN/MAIN
IN) have both LINE2 and MAIN IN functions.
When connecting an analogue audio output
device, switch the input setting of this unit to
"LINE2".
• The factory default is "LINE2".
1 Press [AMP].
2 Press [>INPUT<] repeatedly to select
"MAIN IN".
Using analogue audio output device (LINE1/LINE2)
You can connect the Blu-ray Disc player, etc. with
analogue audio cable (not supplied) to this unit and
play back music.
3 Press [MENU].
4 Press [ ], [ ] repeatedly to select
"Input Mode" and then press [OK].
5 Press [ ], [ ] repeatedly to select
"LINE2" and then press [OK].
6 Confirm the displayed message and
press [OK].
• The volume level set after switching to
"LINE2" is displayed. Confirm and adjust the
volume before pressing [OK].
7 Press [ ], [ ] to select "Yes" and then
press [OK].
Minimising sound distortion
If sound distortion occurs when using the
analogue audio input terminals, setting the
attenuator to "On" may improve the sound
quality.
• The factory default is "Off".
1 Press [AMP].
2 Press [MENU].
3 Press [ ], [ ] repeatedly to select
"Attenuator" and then press [OK].
4 Press [ ], [ ] to select "On" and then
press [OK].
Blu-ray Disc player, etc.
Operations
19
(19)