Technics SUG700E Bedienungsanleitung Seite 28

Settings
System control connection
You can operate this unit and Technics devices supporting
system control function (Network Audio Player, Compact Disc
Player, etc.) simultaneously with ease on the remote control.
For details, refer to the operating instructions of each device.
Network Audio Player, etc.
Using system connection cable and
audio cable
1 Disconnect the AC mains lead.
2 Connect this unit and Technics device
supporting system control function
(Network Audio Player, etc.).
• Use both of the system connection cable and
the audio cables when connecting this unit
and the device.
• Use the system connection cable supplied
with the connected device.
3 Connect the AC mains lead to this unit.
( 15)
4 Press [AMP
5 Press [AMP].
6 Press [SETUP].
7 Press [ ], [ ] repeatedly to select
"System Control" and then press [OK].
28
(28)
] to turn this unit on.
System connection cable
Coaxial digital cable
*
(not supplied)
8 Press [ ], [ ] to select the input
source for the device which is
connected at step 2, and press [OK].
• Select "Off" to disable the system control
function.
: The illustration shows the example when
*
connecting with coax digital cable. Connect
the device with proper cable/terminal
supporting the device.
Note
• When using the system control function by
connecting the Technics device to the LINE2 IN
terminal of this unit, select "LINE2" ( 19) for
the input setting of the analogue audio input
terminals (LINE2 IN/MAIN IN) of this unit.
• When using this unit as power amplifier ( 20),
the system control function for the Technics
device connected to the MAIN IN terminals is
disabled.