Technics SUG700E Bedienungsanleitung Seite 17

USB 2.0 cable
(not supplied)
■
Preparation
Connecting to a PC
• Before connecting to a PC, follow the steps
below.
• Refer to the following for the recommend OS
versions for your PC (as of February 2017):
- Windows 7, Windows 8, Windows 8.1,
Windows 10
- OS X 10.7, 10.8, 10.9, 10.10, 10.11,
macOS 10.12
Download and install the dedicated USB driver
to the PC. (Only for Windows OS)
• Download and install the driver from the
website below.
www.technics.com/support/
Download and install the dedicated app
"Technics Audio Player" (free of charge) on
your PC.
• Download and install the app from the
website below.
www.technics.com/support/
Using USB 2.0 cable
1 Disconnect the AC mains lead.
You can connect the PC, etc. or another device with
USB 2.0 cable (not supplied) to this unit and play back
music.
Audio device with USB-DAC output
terminal such as ST-G30, etc.
2 Connect this unit and a PC, etc.
3 Connect the AC mains lead to this unit.
( 15)
4 Press [AMP
5 Press [>INPUT<] repeatedly to select
"PC".
• You can also select the input source by
turning the input selector knob on the unit.
6 Start playback using the dedicated
app "Technics Audio Player" on the
connected PC.
Note
• When connecting an audio device with USB-
DAC output terminal such as ST-G30, etc., refer
to the operating instructions of the connected
device.
• About supported format, refer to "Format
support". ( 35)
• Windows is a trademark or a registered
trademark of Microsoft Corporation in the
United States and other countries.
• Mac and OS X are trademarks of Apple Inc.,
registered in the U.S. and other countries.
• macOS is a trademark of Apple Inc.
Using PC, etc.
PC, etc.
] to turn this unit on.
Operations
17
(17)