Parkside Performance PPAKS 40-Li B2 Originalbetriebsanleitung Seite 45

separate operating instructions for battery
and charger).
Transport
• Switch off the tool each time before
transport, engage the chain brake and re-
move the batteries.
Troubleshooting
The following table will assist you in fixing faults:
Problem
Device does not start
Poor cutting performance
Device has difficulties running,
saw chain jumps off
Saw chain gets hot, smoke de-
velopment when sawing, dis-
colouration of the rail
Disposal/environmental
protection
Empty the oil tank carefully.
Do not dispose of used oil residues in the
sewage system or down the drain. Dispose
of waste oil in an environmentally friendly
way – take them to your local recycling
centre.
Remove the battery from the device and re-
cycle the device, battery, accessories and
packaging in an environmentally-friendly
manner.
Waste electrical and electronic
equipment (WEEE) must not be dis-
posed of with domestic waste.
• Cover the blade bar and saw chain with
the chain guard (22) when you transport
the tool.
• Short distances at the place of work:
Carry the tool by the front handle (11) with
the blade bar pointing backwards.
• Secure the tool against tipping over dur-
ing transport (including in vehicles) to pre-
vent injury, damage or loss of fuel.
Possible cause
Batteries (17) empty or not in-
serted
On/Off switch (2) is broken
Defective motor
Saw chain (6) incorrectly fitted Installing the saw chain and
Saw chain (6) blunt
Insufficient chain tension
Insufficient chain tension
Not enough chain oil
The symbol of the crossed-out wheeled bin
means that this product must not be dis-
posed of as unsorted municipal waste at the
end of its useful life.
Directive 2012/19/EU on waste electrical
and electronic equipment:
Consumers are legally obliged to recycle
electrical and electronic equipment in an en-
vironmentally sound manner at the end of its
life. In this way, environmentally friendly and
resource-saving recycling is ensured.
Depending on the implementation in national
law, you may have the following options:
• Return to a shop,
• Hand over to an official collection point,
• Return to the manufacturer/distributor.
GB
MT IE
Error correction
Check battery charge level, re-
pair by a qualified electrician if
necessary
contact the service centre.
blade bar, p. 42
• Sharpening the cutting
teeth, p. 44
• Running in a new saw
chain, p. 43
Tensioning the saw chain,
p. 37
Tensioning the saw chain,
p. 37
• Checking the oil level and
oil automation
• contact the service centre.
NI
45