Operation - Parkside Performance Ppards 16 D3 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

WARNING! Risk of accidental
m
contact of spray materials with
skin and eye.
The maximum volume of the spray
u
tank is 16 litres. Do not overfill
[ 3 ]
the spray tank!
NOTE
Thoroughly clean and rinse
u
measuring containers that are used
for filling the spray tank
pre-mixing spray materials.
The basket filter
u
that can clog or damage the pump
from entering the spray tank.
Always reinsert the basket filter
u
before reinstalling the spray tank
cover .
8 ] [
Use only with plant protection
u
products approved by local/
national regulatory authorities for
plant protection products for use
with backpack sprayers.
Before filling the spray tank with spray
solution
1. Carry out a test run with fresh water.
Check all parts of the product for
leaks.
Filling a clean spray tank
1. Stand the spray tank
surface.
2. Unscrew and remove the spray
tank cover . Check if the basket
8 ] [
filter is correctly placed (Fig. E).
26 ] [
3. Carefully pour up to 16 litres of the
spray solution into the spray tank
4. After filling, fit the spray tank
cover . Tighten the spray tank
8 ] [
cover firmly.
24 GB/IE/NI/MT
and for
3 ] [
prevents debris
26 ] [
on a level
3 ] [
3 ] [
NOTE
Fix a tag on the product to note
u
what chemical is used.
WARNING!
m
Never attempt to fill the spray
u
tank while carrying it.
3 ] [
Changing the spray material
If any spray material is left in the spray
tank :
[ 3 ]
1. Unscrew the spray tank cover
remove the basket filter
2. Pour the spray material from the
spray tank
3 ] [
approved for chemicals. Do not store
chemicals in the spray tank for a
prolonged period.
3. Use clean water to clean and rinse
the spray tank
A small amount of mild household
detergent may be added.
4. Pour in the new spray material
(see "Filling the tank").
˜ Operation
˜ Switching on and off
(Fig. B)
Switching the product on sets the
product into standby. The product does
not spray until the trigger
while the product is switched on.
Switching on:
Press the on/off switch
o
Increasing the pressure
.
Press the pressure selection
o
button .
16 ] [
The pressure increases each time
o
the button is pressed, until setting 6,
then the pressure returns to setting 2.
[ 8 ]
.
26 ] [
into a container
and accessories.
3 ] [
is squeezed
28 ] [
.
14 ] [
and