Residual Risks; Operation; Checking The Charge Status Of The Battery; Charging The Battery - Parkside Performance Hg13526 Bedienungsanleitung/Originalbetriebsanleitung

˜ Residual risks
There will always be residual risks even
if you operate this power tool according
to the instructions. The following
hazards may occur in connection with
the type and design of this power tool:
Cutting injuries
Health injuries resulting from the
effect of hand/arm vibration in the
event that the device is used over a
longer period of time or is not used
and maintained properly.
WARNING!
m
During operation, this power tool
u
produces an electromagnetic held.
Under certain circumstances, this
held may negatively affect active or
passive medical implants. In order
to reduce the danger of serious
or fatal injuries, we recommend
that individuals who wear medical
implants should consult their
doctor and the manufacturer of
the implant before operating the
machine.
Observe the safety information
u
and notes on charging and
proper use as shown in the
instruction manual for your
battery and charger of the X 20 V
Team series from Parkside.
A detailed description of the
charging process and further
information can be found in the
separate operating instructions.
34 GB/IE
˜ Operation
WARNING!
m
Do not use the device without
u
safety goggles. Prior to each use,
ensure that the machine is working
correctly. Risk of injury and
damage to property.
˜ Checking the charge status
of the battery
The battery charge status indicator
o
shows the charge status of the
15 ] [
battery .
[ 17 ]
The charge level of the battery
o
indicated by the corresponding LED
light lighting up when you press the
soft key .
18 ] [
Colour
Red/orange/
green
Red/orange
Red
˜ Charging the battery
NOTE
Charge the battery
u
the red LED of the charge level
indicator is still lit.
[ 15 ]
1. Remove the battery
device.
2. Slide the battery
slot of the charger
3. Plug the charger into an outlet.
4. After charging is complete, a green
light will be illuminated permanently.
You can now disconnect the charger
from the mains supply.
5. Remove the battery
charger.
is
[ 17 ]
Charging level
battery fully
charged
battery approx.
half charged
battery needs to
be charged
when only
[ 17 ]
from the
17 ] [
into the charging
[ 17 ]
.
[ 14 ]
from the
17 ] [