Checking The Battery Charge Level; Charging The Battery; Inserting And Removing The Battery; Working Instructions - Parkside Performance Ppbs 3 B2 Originalbetriebsanleitung

GB
MT
2. Adjust the strap length so that the click
fastener (43) is at hip height.
3. Attach the device to the double shoulder
strap (42): Close the click fastener (43).
4. Place the hip protector (44) on your hip
between your body and the device.

Checking the battery charge level

LEDs
red, orange, green
red, orange
red
1. Press the button (38) next to the charge
level indicator button (39) on the battery
(37).
The LEDs of the charge level indicator
show how much charge remains in the
battery.
2. Charge the battery (37) when only the red
LED on the charge level indicator (39) is
illuminated.

Charging the battery

See also the charger instruction manual.
Notes
• If warm, allow the battery to cool before
charging.
• Do not expose the battery to direct sun-
light or temperatures max. 50 °C for long
periods of time. In particular, avoid pla-
cing the product on radiators or storing it
in vehicles parked in the sun.
Procedure
1. If necessary, remove the battery (37) from
the cordless tool.
2. Slide the battery into the charging slot of
the charger (41).
3. Plug the charger into an outlet.
4. Once charging is complete, disconnect
the charger from the mains supply.
5. Pull the battery charging slot out.
Inserting and removing the
battery
WARNING! Risk of injury due to uninten-
tional start-up. Only insert the battery into
the device once the device is fully prepared
for use.
NOTICE! Risk of damage! An incorrect bat-
tery can damage the device and battery.
40
Meaning
Battery charged
Battery partially
charged
Battery needs to be
charged
Inserting the battery
1. Push the battery (37) along the guide into
the battery holder (3).
You will hear the battery click into place.
Removing the battery
1. Press and hold the battery release (40) on
the battery (37).
2. Pull the battery out of the battery holder
(3).

Working instructions

Work safely, giving due consideration to the
next steps!
• When strimming, pay attention to coun-
try-specific regulations and/or those of
your local municipality.
• Do not do strimming work during general
rest periods.
• Solid items such as stones, metal parts
and similar are to be removed. These can
be ejected and lead to personal injury and
damage to property.
• When strimming high bushes or hedges,
the working height should be at least 15
cm. This means that animals like hedge-
hogs are not put at risk.
• Always hold the device tightly and se-
curely with both hands!
• Only cut grass and weeds with the spool
and steel cutter! A clearing blade can be
used to cut thickets and small logs up to
20 mm in diameter. Watch out for roots or
tree stumps, there is a risk of tripping.
• Work carefully and do not endanger any-
one while you are strimming.
• You should only work in good lighting
conditions with sufficient visibility!
• Keep an eye on the cutting head!
• Never strim above shoulder height!
• Never replace the plastic cord with a steel
wire – risk of injury and damage!
• Never work on a ladder!
• Only work on firm and stable surfaces!
• Avoid an abnormal body posture. Ensure
that your footing is secure and keep your
balance at all times.
• Change your working position at regu-
lar intervals in order to prevent becoming
tired on one side of your body.
• If the cutting head is blocked: Switch
off the device, wait until all moving parts
have come to a complete standstill and
remove the spark plug connector. Then
remove the blocking.