Herunterladen Inhalt Inhalt Diese Seite drucken

Storage; Troubleshooting; Error Correction - Parkside Performance Ppbs 3 B2 Originalbetriebsanleitung

Benzin-sense mit elektrostart
Inhaltsverzeichnis
Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1

Storage

General storage instructions
• Clean and maintain the device and ac-
cessories carefully before storage.
• Store the device in a dry and dustproof
location and out of reach of children.
• Do not wrap the device in plastic bags as
moisture and mildew may form.
• Do not lie the device down on the pro-
tective cover.
• Use transport protection (29/31) when
storing the blades.
• The cable holders (11) should hold the
device cord (13) in position. Do not re-
move the cable holders, even when stor-
ing the device.
Storage when not in operation
 CAUTION! Fuel residues in the carburet-
tor can cause starting problems or perman-
ent damage to the device.

Troubleshooting

The following table will assist you in fixing faults:
Problem
Engine will not start
Engine runs too fast at idle
For operational breaks of up to 3 months
1. Empty the fuel tank (5) in a well-ventil-
2. Start the engine, allowing it to idle until
3. Let the engine cool off (about 5 minutes).
Further measures for breaks in operation
of more than 3 months
1. Remove the spark plug (66) with the
2. Fill a teaspoon with pure 2-stroke oil into
3. Pull the starter cord slowly several times
4. Put the spark plug (66) back in.
Possible cause
No fuel in the tank
Incorrect starting sequence
Engine is "flooded"
Sooty spark plugs, incorrect
ignition gap
Spark plug connection or igni-
tion cable defective
Carburettor, carburettor jets
dirty, incorrect carburettor mix
setting
Clogged fuel filter
Battery (37) is empty or not in-
serted
Engine cold
ated place.
the engine stops and the carburettor is
free of fuel.
combination tool (33) (Checking/
adjusting/replacing spark plug, p. 45).
the combustion chamber.
to distribute the oil inside the engine.

Error correction

Mixing and filling fuel, p. 39
Start the engine, p. 42
Let off throttle, start engine
several times, remove, clean
and dry the spark plug if ne-
cessary
Checking/adjusting/replacing
spark plug, p. 45
Replace
Adjusting the carburettor,
p. 46
Replacing the fuel filter,
p. 46
Charge the battery (see the
separate operating instructions
for the rechargeable battery
and charger)
Warm up slowly
GB
MT
47
Inhaltsverzeichnis

Fehlerbehebung

loading

Diese Anleitung auch für:

495693 2504

Inhaltsverzeichnis