RF GF(S) (2) (XL) SW2.4LE-IND
Montage- und Anschlussanleitung / Funkschalter
Mounting and wiring instructions / Wireless switch
Instructions de montage et de câblage / Interrupteur de radio
English
Typical ranges:
Location
indoors (line of sight)
Mounting and wiring
=
CAUTION
Risk of tripping!
Do not place the device in walkways.
Secure the device on a flat surface (inclination <35°).
Pairing
See section »Pairing«.
Commissioning and operation
=
CAUTION
If the power supply unit is incorrectly connec-
ted, there is a risk of burns. Only use the power
supply unit supplied.
The foot switch has a built-in lithium-ion battery. When delivered, it is
typically pre-charged to a capacity of 25 to 30 %. Therefore, recharge
the battery using the supplied power supply unit before using it for the
first time.
Flashing codes
The device has two LEDs:
LED
Name
Connect LED
Battery LED
The following flashing codes are possible:
Off
Off
Off
On
Green
-
Wireless range
(approx.)
max. 45 m
significance
The Connect LED indicates the
connection status.
The battery LED indicates char-
ging activity and the battery
charge level.
Significance
Device in standby mode.
The device is not paired with any
receiver.
Radio connection established.
Flashing
-
green (slow)
Green
-
flashing
(short
pulse)
Red
-
flashing
(slow)
Red
-
flashing
(fast)
Red
Orange
-
Off
-
Green
-
Orange
-
Orange
flashing
(fast)
-
Green
flashing
5 / 20
Significance
Radio connection established,
reception quality limited.
Foot switch is in advertising mode.
Device is in pairing mode.
Confirmation of pairing by the
recipient required.
Serious error.
Maintenance required.
Operating mode:
Foot switch in idle state.
Charging mode:
Battery is not charging.
Check plug connections.
Operating mode:
> 50% battery capacity.
Charging mode:
Battery fully charged.
Battery capacity between 20%
and 50%.
Battery charge below
the threshold value.
Device must be charged.
Charging mode:
Battery is charging.