Fuxtec FK-RM Serie Original Bedienungsanleitung Seite 54

Original User Manual FUXTEC FX-RM Series_de_en_fr_ita_es_rev24
IMPORTANT: on some models, the front wheels are removed to prevent damage to the axle during
shipping. The wheels are simply screwed onto the axle with the nuts supplied.
Raise the wheels for low cutting height and lower the wheels for high cutting height. Adjust the cutting
height according to your needs centrally using the height adjustment handle (see illustration on page 2).
The middle position is the most suitable position for most lawns.
Before each subsequent use, check the oil level and, if necessary, top up with SAE30 engine oil. Refer to
the table in Chapter 1 Product Specification for the filling quantity.
could lead to the smoke formation in the muffler when starting.
3. Insert the dipstick and pull it out slowly to check the oil level
- Check the oil level before each use. Add oil if necessary. Fill up to the oil gauge on the dipstick.
- Change the oil every 25 working hours or every season. You will likely need to change the oil more often
in dusty and dirty conditions. Refer to chapter 10 "Changing the oil."
Fill the fuel tank to the bottom of the filler neck. Do not overfill the tank. Use fresh, clean unleaded fuel.
Never mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to guarantee the
Prolonged storage of the lawnmower will change the chemical composition of the gasoline, which can
cause starting difficulties and unsteady running of the engine.
ATTENTION:
Remove any oil or gasoline residue. Do not store, spill, or use gasoline near naked flames.
ADJUSTING THE CUTTING HEIGHT
FILL OIL BEFORE STARTING THE ENGINE
1. Make sure that the lawnmower is level
2. Remove the dipstick from the oil filler tube
IMPORTANT:
Refuel with SUPER GASOLINE 95 octane (no mixture)
freshness of the fuel.
Your lawnmower is delivered to you without 4-stroke
ATTENTION:
DO NOT overfill the engine with oil. It
54
oil.