monolith TWO.66 Schnellstartanleitung Seite 12

22
CLEANING AND USE
The grill does not have to be seasoned and can is enough charcoal in the grill (if necessary,
be used immediately after being set up. The add some charcoal). High temperatures are
grill does not require any further treatment, reached very quickly, and the heat will burn
such as application of oil for seasoning. The any organic residue to a fine ash (pyrolysis). We
cast iron charcoal grate leaves the factory with recommend heating the grill up to 400 °C for
a protective coating which safeguards it against 10 minutes.
corrosion during storage. This protective coa-
Warning: Do not allow the grill to heat up to
ting burns off during the initial use. Please wait
until any odour caused from burning of the more than 400°C, especially the MONOLITH Basic,
protective coating clears before placing food on as this could damage the gasket between the
the grill. unit and the lid. Never leave the grill unattended
during pyrolysis.
CLEANING
Always remove the MONOLITH Smart Grid
System before pyrolysis.
Only clean the exterior of the grill and the stand
and bamboo side tables with water and a mild Finally brush the grate with a grill brush. Remo-
cleaning agent. ve the burnt residue on the lid and the other
internal components with a hand brush or
Never use water or other liquids to clean the bristle brush. The cast iron grate and charcoal
inside. The inside of the grill can be cleaned basket can be cleaned with a brush; occasional-
with high temperatures after use. To do this, ly coat the cast iron grate with a thin layer of oil
fully open both air vents. First ensure that there to protect against rust.
Attention: The light ceramic of the interior will
gradually darken. This is not a defect, but is rather
an effect of combustion, smoke and grease.
CLEANING THE GRILL
GRATES
Clean the grates while still hot with a grill brush,
to remove larger materials. The grill grates are
made of stainless steel and are dishwasher
safe. Only use suitable cleaning agents. The
grates may be permanently discoloured (tarn-
ished) by the high temperatures the grill can
reach.
ATTENTION!
Please read the instructions manual carefully and in full, in order to prevent
operating errors and consequent forfeiture of warranty claims.
CLEANING THE PIZZA AND
remove the ashes through the opening.
DEFLECTOR STONE
We suggest occasionally removing all the
components from the unit and cleaning the
The pizza stone and the deflector stone are grill with a brush to thoroughly remove all ash.
made of open-pored ceramic, and therefore
liquids and fats can soak or burn into the
CLEANING BY PYROLYSIS
material and cause permanent black spots
on the surface. These spots are harmless and
do not constitute defects. To remove larger If the grill has not been used for a long time,
materials, simply scrape with a grill brush or when there is high humidity damp can enter
scraper/spatula. In the absence of the Smart from the outside and mould may form on
Grid System drip pans the deflector stone any organic materials that have not been
can be wrapped in aluminium foil to protect removed on the ceramic and the grates.
from dripping fat. This mould is harmless. It can be removed by
hand with a spatula or a brush. Heat the grill
up so that the moisture can be evaporated
REMOVAL OF ASHES
from the ceramic. Raise the temperature
slowly and burn off all the residue. The heat
After the grill has cooled down, the loose ash will destroy any fungal spores.
in the charcoal basket can be simply shaken
off, so that it falls into the ash chamber of the
fire box. If required, remove the cast iron fire
grate beforehand. Now use the ash shovel to
23
i
MORE
QUESTIONS?
Under this link you will find complete
manuals, catalogues and further infor-
mation.
We wish you many hours of grilling fun,
and great embers, always!