Werbung
Verfügbare Sprachen
Verfügbare Sprachen
period (about 2 minutes).
depends on the heating of motor winding and ambient temperature.
Zusatzhandgriff
The supplied handle must be fixed securely onto the gearbox housing
and must always be used during operation.
Water Supply WPN 180
The machine has an external water supply via the working spindle. The
water volume can be regulated as required by a ball valve. The water
supply is equipped with a connector for Gardena – hose couplings.
Attention! The max. water pressure should not exceed 3 bar.
In case water leaks in the water supply, stop working and have the tool
repaired by an authorised service workshop.
Care and Maintenance
Before the beginning of maintenance or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only by appropriately qualified and experienced
personnel.
After every repair the machine has to be inspected by an
electric specialist.
Due to its design, the machine needs a minimum of care and maintenance.
However, the following points always have to be observed:
Always keep the power tool and the ventilation slots clean.
During work, please pay attention that no particles get inside the
machine.
In case of failure, a repair has to be carried out by an authorised
service workshop.
Environmental Protection
Raw Material Recycling instead of Waste Disposal
To avoid damages on transportation, the power tool has to be delivered in
a sturdy packing. Packaging as well as unit and accessories are made of
recyclable materials and can be disposed accordingly.
Press the on/off switch. The cooling period
15
Werbung
