Eibenstock ESR 500 Originalbetriebsanleitung Seite 15

Operation
mation sheet. This could lead to underestimation
of vibration when the tool is used regularly in such
a manner.
Note: To be accurate, an estimation of the level of
exposure to vibration experienced during a given
period of work should also take into account the
times when the tool is switched off and when it is
running but not actually when doing the job.
This may significantly reduce the exposure level
over the total working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as:
maintain the tool and accessories, keep the hands
warm, organisation of work patterns.
4. Operation
Before carrying out any work on the
machine, pull the mains plug.
Putting into operation
Observe correct main voltage!
Before putting into operation, check that the mains
voltage and frequency on the identification plate
match the details of your mains supply.
If using an extension cable: Only use
extension
approved for the application with the
required cross-section. Otherwise the
power of the tool can be reduced and
the cable can overheat. Replace
damaged cables.
Mains Cable
If the mains cable is damaged while
working, pull the mains plug immedi-
ately.
Operation
Adjusting the Screw-in Depth
The adjustment of the screwing depth takes place
with the adjustment ring 3.
1 Revolution = 1,6 mm.
cables specifically
3
Turning to the right:
The screw is set deeper.
3
Turning to the left:
The screw is set less deep.
The required setting is best determined by testing.
Selecting the direction of rotation
Operate the rotational direction switch 6 only
when the machine is at a standstill!
Grip the rotation direction changeover switch 6 on
both sides and set the required direction of rota-
tion.
Clockwise rotation:
For drilling and fixing screws.
Anticlockwise rotation:
For loosening and removing screws
and nuts.
Important: Press the rotational direction switch 6
up to the stop on the housing, i. e. until it snaps in
audibly.
If the rotational direction switch 6 is set between
the positions "R" and "L", the machine cannot be
switched on.
On-/off
Press or release the On/Off switch 4. The On/Off
switch 4 can be locked using the locking button 5.
Release the On/Off switch 4 by pressing and re-
leasing briefly.
Make sure that the machine is not
blocked longer than 2-3 seconds.
The motor can get damaged if
blocked longer.
The bit rotates only after the screw is in contact
and pressure is applied to the machine.
Changing the speed
The On/Off switch 4 can be used for infinitely var-
iable speed control. Light pressure on the On/Off
switch 4 causes the machine to rotate slowly; with
increased pressure, the speed increases.
English 15