Factory Settings; Operating Voltage - Electro-Voice TG-7 Bedienungsanleitung

Factory Settings

Parameter
Power-On-Delay
Breaker Current (dependent on the mains)
Amplifier Name
LCD Contrast
LCD Brightness High
LCD Brightness Low
LCD Time to Dim
Temperature Unit

2.2 Operating Voltage

The power amplifier receives its power supply via the MAINS IN connector, which is designed as a Neutrik
PowerCon® connector
CAUTION:
The Powercon is a connector without breaking capacity, i.e. the Powercon
®
not be connected or disconnected under load or live.
Control
Mains Switch
Level CH A
Level CH B
Table 2.1: Factory Settings of the Controls
Table 2.2: Factory Settings of the LC-Display
Controls
ROUTING
MODE
SENSITIVITY/GAIN
GROUNDLIFT
Table 2.3: Factory Settings of the Rear Panel Controls
TOUR GRADE SERIES
Setting
off
0dB
0dB
Value
0.00 s
16 A (230 V) / 30 A (120 V)
Electro-Voice TG-5 or Electro-Voice TG-7
50%
90%
40%
Autodim off
°C
Setting
DUAL
NORMAL
0dBu
GROUNDED
should
®
Owner's Manual 9