Distance To Combustible Material - Nordpeis N-36A Exclusive Montageanleitung

Insert
Material
Surface treatment
Weight of insert (kg)
Draught system
Combustion system
Combustion air
consumption (m³/h)
Operating range, Clean burn
(kW)
Heating area (m )
2
Maximum fuel length (cm)
Flue outlet
Flue (Ø mm)
Flue gas temperature at flue
connector (°C)
Draft at flue connector
recommended (Pa)
Data according to EN 13 229
Area of convection air vent
under insert (cm )
2
Area of convection air vent
over insert (cm )
2
Minimum distance conv. air
outlet to ceiling (mm)
Nominal heat output (kW)
Efficiency (%)
CO @ 13% O (%)
2
Flue gas temperature (°C)
Draft (Pa)
Fuel recommended:
Fuel length recommended
(cm)
Fuel charge (kg)
Refueling interval
(minutes)
Opening of the air vent
control (%)
Operation
* Intermittent combustion refers to normal use of a fireplace, i.e. new
wood is inserted when the previous load has burned down to ember
Warning: If the requirements for ventilation are
NOT complied with, the cooling airflow around the
product will be considerably reduced and
the product can overheat.
This can cause a fire.
12
N-36A Exclusive
Steel
Heat resistant varnish
115
Air vent control
Secondary combustion
(clean burning)
24
4,5-10
50-150
35
Top and rear
Outer 150
*alternate versions exist
due to national
requirements
344
14-25
400
475
580
7,0
78
0.09
286
12
Wood
30
3,05
60
60%
Intermittent*

3. Distance to combustible material

Firewall
Ensure that the safety distances are fulfilled.
(FIG 1).
When connecting a steel chimney to the top outlet use
the security distances required by the manufacturer.
Important! When placing the insert on a
combustible floor, a steel plate of at least 0.7mm
must cover the entire floor surface inside the
surround. Any flooring made of combustible
material, such as linoleum, carpets etc. must be
removed from underneath the steel plate.
The insert expands when in use, and for this
reason the surround must NEVER rest on the
insert, but have a gap of about 3 mm. The
insert must neither rest on the bench plate
or against the sides. It is recommended to
dry stack the surround in order to adjust the
insert prior to perforating the chimney for the
4. Assembly
1. Check the packing list to Ensure that all loose parts
are included.
Assembly and adjusting the legs FIG 4
The insert is delivered with adjustable legs. These can
be mounted on the insert using the added washers and
bolts FIG 4.
Carefully lay the insert on its back. Ensure that the
transportation padding is put inside the insert before
turning it over, so that the insulating plates in the burn
chamber do not fall down and break.
Fasten the screws on to the insert with a 13 mm
spanner/wrench.
Adjust the legs (FIG 4) to the desired height before
returning the insert to an upright position (do not tilt
the insert). The height varies according to the
surround.
Door and frame FIG 5-9
In order to avoid damage to the glass, please
remove the door prior to handling and installation as
illustrated Fig 5-8
FIG 5
The door is opened by pulling the handle out and
upwards.
GB
flue connection.