HOMCOM YH2303 Bedienungsanleitung Seite 15

EN
Safety Cut-Off
This appliance is fitted with a safety cut-off which will operate if the fire overheats (e.g.
Due to blocked air vents). For safety reasons, the fire will NOT automatically reset.
To reset the appliance, disconnect the appliance from the mains supply for at least 15
minutes. Reconnect the supply to the mains and switch on the appliance.
Overheating safety device
If the heater stops working, turn the heater off and inspect the blockage of inlet or
outlet. Disconnect the plug and wait at least 10 minutes for the protection system to
reset before attempting to restart the heater. If the safe device still switches the heater
off and makes the heater fail to operate, take the heater to your nearest service center
for examination or repair.
ATTENTION:
10 minutes
Cleaning
1. Always disconnect the appliance from the main supply before cleaning.
2. Clean the outside of the heater by wiping with a damp or dry cloth.
3. Do not use petroleum, any other detergent or chemical solvent to clean the heater.
4. When the heater is not used for a long time, it should be protected from dust and
stored in a clean dry place.
Disposal
Environmental Protection
Waste electrical production should not be disposed of with household waste.
Please recycle where facilities exist. Check with your local authority or retailer
for recycling advice.
before restarting the heater, the plug must be disconnected for at least
15