Remote Operation - Homcom Yh2303 Bedienungsanleitung

EN
①Power switch ON/OF.
②Heating setting: Heat power 1000W and 2000W
③Flame color setting : five color cycle adjustments .
④Timer: Timing 1-12 hours .
⑤Temperature down setting .
⑥Temperature up setting .
Use
The device can be operated either via the controls on the device or by means of the
remote control.
1. Press the power switch button ① to turn on the fireplace.
2. Press the heating button to switch power ②, with high power displaying HI (2000W)
and low power displaying LO (1000W)
3. Press the temperature setting button ⑤⑥ to adjust the temperature, with a
temperature setting range of 15-35 ℃. Press the up button to increase the
temperature, and press the down button to decrease the temperature. The default
temperature is 25 ℃.
4. Press the flame brightness button ③ to set the flame color change , there are five
color cycle adjustments:L0-L1-L2-L3-L4-L5-L6, L0- turn off the flame.
5. Press the timer button ④ to set the timer function, 01-12 hours

Remote Operation

• The standby switch located at the front right hand side above the fire must be first
switch on.
• It takes some time for the receiver to respond to the transmitter. Do not PRESS the
buttons more than once within two seconds for correct operation.
BATTERY REPLACEMENT-REMOTE CONTROL
1. Batteries Not Included
2. To replace the existing battery remove the battery holder.
3. To remove the battery holder turn remote onto rear side and press the left side lever
towards the center while pulling the battery holder out using the slot provided.
4. Replace existing battery, type CR2025, with a new battery and reinstall the battery
holder into the remote by sliding it into position, as shown:
13