Ruris R-Power IS2000 Handbuch Seite 18

EN
Careful!
● If a consumer that is connected to the generator, starts working abnormally, becomes slow or stops suddenly,
turn it off immediately. Disconnect it from the generator and determine if the load is faulty or if the load capacity
of the generator has been exceeded.
● If the generator needs to be connected to the household power supply, only electrical technicians will make the
connection. Any improper connection may result in a fire hazard or damage to the generator.
● The overload protector will be tripped automatically when the circuit is overloaded.
● During use, the generator must be connected to earth to prevent any kind of danger.
STOPPING THE ENGINE
To stop the engine, turn the engine switch to the
"OFF" position.
Disconnect electrical appliances from the generator.
After the engine has cooled completely, turn the fuel
tank valve actuation knob counterclockwise to the
"OFF" position.
Make sure the tank valve actuation knob and engine switch are in the "OFF" position when shutting down,
transporting, and storing the generator.
Proper maintenance is the responsibility of the owner. See maintenance plan for specific maintenance. Note
that this list is made under the general conditions under which the gasoline engine is used. If it is used
continuously under heavy load or under high temperature with improper humidity or dusty environment,
maintenance should be done more often.
Replacement of spare parts
It is recommended to use only original spare parts. Substitution with inferior quality replacement parts may
adversely affect the performance of the emission control system.
Unauthorized changes
Unauthorized modifications or changes to the emission control system may cause emissions to exceed legal
specifications. Unauthorized modifications or changes include:
1) Removal or replacement of any spare part in the intake or exhaust system.
2) Altering or removing connections for the rev control system that causes the gasoline engine to operate
beyond the parameter settings.
Emissions may be adversely affected if:
1) Black smoke is emitted or fuel consumption is high;
2) During the operation of the engine, there are misses in the carburetor or in the muffler;
3) Ignition occurs earlier or later than normal.
Periodic inspection and adjustment can keep your gasoline engine performing well and extending its life.
Maintenance intervals and items are shown in the following table:
MAINTENANCE TABLE
Interval
Operation
Engine oil check
7
7. MAINTENANCE AND TROUBLESHOOTING
With every
use
A
After 5h or After 25
after the first hours or 6
use months
After
After 200h or
100h or 6
after 2 years
months