Test Symbols; Appliance Description; Operation; Switching The Appliance On And Off - STIEBEL ELTRON CNS 50 SE Bedienung Und Installation

opErATIoN

Appliance description

WARNING Burns
Never operate this appliance...
- in rooms where the appliance is at risk of fire or
explosion as a result of chemicals, dust, gases or
vapours.
- in the direct proximity of pipes or receptacles that
carry or contain flammable or explosive materials.
- if work such as laying tiles, sanding or sealing is
being carried out in the installation room.
- if sprays, floor polish or similar products containing
naphtha are used. Ventilate the room sufficiently
before heating.
- if the minimum clearances to adjacent object sur-
faces are not maintained, for example to furniture,
net curtains, curtains, textiles or other flammable
materials. Observe the minimum clearances.
- if an appliance component is damaged, the appli-
ance has fallen over or already has a fault.
WARNING Burns
Never place any flammable, combustible or insulating
objects or materials, such as laundry, blankets, maga-
zines, containers with floor polish or naphtha, spray cans
or similar on the appliance or in direct proximity to it.
CAUTION Burns
Parts of the appliance can get very hot and may cause
burns. Particular caution is advised when children or
vulnerable persons are present.
WARNING Overheating
In order to avoid overheating, do not cover the heater.
Material losses
!
- Never step on the appliance.
- Never operate the appliance in the open air.
2.3

Test symbols

See type plate on the appliance.
3. Appliance description
The appliance is a wall mounted electric direct heater.
The appliance is suitable as a full heating system, or for use be-
tween seasons and as a booster heater in smaller rooms, such as
hobby and guest rooms.
The air in the appliance is heated by a heating element and ex-
pelled via natural convection through the air outlet grille at the
top. Cool room air flows in through the apertures at the bottom
of the appliance.
Series CNS-SE
After mounting the appliance on the wall and making the elec-
trical connection using a mains plug, the appliance is ready for
operation.
14 | CNS SE | CNS UE
Series CNS-UE
Once the appliance has been mounted to the wall and a permanent
electrical connection has been made using a junction box, the
appliance is ready for operation.
4. Operation
3
1 ON/OFF switch
2 Temperature selector
3 Operating selector
4.1

Switching the appliance on and off

f Switch the appliance ON and OFF via the switch on the r.h. f
side of the appliance.
4.2

Description of the user interface

You can select the following 4 functions at the operating selector:

Comfort mode

ECO mode (night setback)
Frost protection
Automatic
f Set the required room temperature via the continuously vari- f
able temperature selector (for temperatures see specification
chapter).
As soon as the selected room temperature is reached, it is con-
stantly maintained at this selected temperature through periodic
heating (the output of the appliance must correspond at least to
the required heat demand of the room).
If several appliances are installed in a single room, the setting
at the temperature selector on each appliance can be different.
Note
To avoid excessive power consumption when windows
are open, switch the appliance off while airing.
4.3 Comfort mode
f Set the operating selector to comfort mode f
On this setting heating stops as soon as the room temperature set
at the temperature selector has been reached. The room temper-
ature is then kept constant through periodic heating.
4.4

ECO mode

f Set the operating selector to ECO mode f
On this setting the comfort temperature set at the temperature
selector is automatically reduced by 3 °C.
1
2
.
.
www.stiebel-eltron.com