Operation - EINHELL RT-MG 12 Li Originalbetriebsanleitung

5.2 Triangular sanding/grinding plate
Fit the triangular sanding/grinding plate to use the
equipment as a delta sander/grinder.
5.2.1 Fastening the sanding/grinding paper
The Velcro fastener enables easy changing of
sanding/grinding paper. Make sure that the va-
cuum extraction holes on the sanding/grinding
paper and the sanding/grinding disk are aligned.

6. Operation

6.1 Charging the battery (Fig. 1/4)
1. Remove the battery pack (9) from the handle
(Fig. 1) by pressing the pushlock buttons (11)
on the left and right side of the battery pack
(9).
2. Check that your mains voltage is the same
as that marked on the rating plate. Plug the
battery charger (3) into the power socket
and connect the charging cable (a) to the
charging adapter (6). The green LED on the
charging adapter (6) then comes on.
3. Plug the battery pack (9) into the charging
adapter. The green LED and the red LED will
come on to indicate that the battery pack is
being charged.
4. When the charging period is completed after
approx. 3 hours, the red lit LED will go out
again.
The temperature of the battery (9) may rise during
the charging operation. This is normal.
If the battery pack fails to charge, check for the
following:
•
Voltage at the power socket
•
Good contact at the charging contacts of the
charging unit
If the battery pack still fails to charge, send
•
the charging unit
•
and the battery pack
to our customer service center.
6.2 Switching on/off (Fig. 5)
Slide the switch (1) forwards to switch on the
equipment.
Anl_RT_MG_12_Li_SPK1.indb 16 Anl_RT_MG_12_Li_SPK1.indb 16
GB
6.2 Practical tips
•
Switch on the equipment.
•
Work away from the body.
•
Never move your hands into the direct vicinity
of the work area.
•
Use only plug-in tools which are in good wor-
king order and undamaged.
Plug-in tools
Sawing: Sawing wood and plastic.
Notes on working practice: When sawing, watch
out for foreign bodies in the workpiece and remo-
ve these if necessary. Plunge cutting is allowed
only in soft materials such as wood or plaster-
board.
Sanding/grinding: Surface sanding/grinding at
edges, in corners or hard-to-reach areas. Depen-
ding on choice of sanding/grinding paper for the
sanding/grinding of wood, paint, lacquer, etc.
Notes on working practice: This equipment off ers
particularly high performance for the sanding/
grinding of hard-to-reach corners and edges. To
sand/grind profi les and channels you can also
work with just the tip or the edge of the sanding/
grinding disk. Various sanding/grinding papers
are available, specially designed for the diff erent
types of material you may be working on and the
amount you wish to remove from the surface.
The amount removed will depend largely on the
choice of sanding/grinding paper and pressure
applied to the sanding/grinding disk.
Scraping: Scraping off old paint or adhesives.
Notes on working practice: Move the plug-in tool
against the area you want to remove. Begin with
a fl at angle of incidence and little pressure. The
surface (e.g. wood, plaster) may be damaged if
too much pressure is used.
6.4 Speed control (Fig. 6)
You can select the speed by turning the speed
controller (4).
Plus direction: Higher speed
Minus direction: Lower speed
- 16 -
14.04.15 09:53 14.04.15 09:53