Charging The Battery Pack; The Remote Control System - Graupner Gm-Racing Radicator Elektro 1/10 4Wd Bedienungsanleitung

TOOLS
In addition to the tool that accompanied the vehicle, the following tools are useful and - in some cases -
necessary:
• Small fl at and small Phillips screwdriver
e.g. No. 98116.12 and 98116.15
• Needle nose pliers
• Glow-Plug Screwdriver
• Phillips screwdriver # 1 or # 0
• Hex wrench with 1.5 mm, 2 mm and 2.5 mm

CHARGING THE BATTERY PACK

First you must load the battery pack with the enclosed battery charger.
Battery capacity
1800 mAh
2400 mAh
3000 mAh
4000 mAh

THE REMOTE CONTROL SYSTEM

Here you get an overview of the remote control system of the Radicator-RTR and its various functions and settings.
Before the fi rst trip you should know and understood these functions.
Place 8 AA batteries in the battery compartment of the transmitter. Pay attention to the polarity!
Remote Control (transmitter)
1. On / off switch: Turns the power on/off
2. Steering wheel: Controls direction (left/right) of the model
3. Steering trim: Adjusts the "hands off" direction of the model
4. Throttle Trigger: Controls speed (forward/brake) of the model
5. Throttle Trim: Adjusts the motor speed to stop at neutral
6. Control light: indicates adequate battery power
7. Antenna: Transmits signal to the model
8. Servo reverse: Reverses the function of the steering or throttle (here are no adjustments necessary)
GM-Racing 90500 - 90500.RTR Radicator 4WD
Charging time approx.
5 h
7 h
9 h
12 h
In order to charge the battery pack must be connected to the battery char-
ger, the loading procedure starts automatically. Disconnect the battery
from the charger according to the time indicated in the chart or if it beca-
mes lukewarm. Never charge the batteris unsupervised! Read also
the enclosed battery safety instructions!
06