Charging Of The Lipo Battery Pack - GRAUPNER micro light indoor Montage- Und Betriebsanleitung

The so-called control box contains receiver, gyro, mixer and 2 ESCs built in one box. It is fac-
tory-installed and upper motor, lower motor, battery jack and two servos are connected to it.

Charging of the LiPO battery pack

Fig. (2) shows the 2-cells / 500 mAh LiPo battery pack, the LiPo charger and the adapter which
converts the AC current into 12 V DC as the input of the LiPo charger.
The AC adapter is not a charger! Under no circumstances it can be connected to the
transmitter's charging jack !!!
The Li-Po charger has an input socket (5); by this you can connect it to your 12 V car battery us-
ing an apropriate cable (not included) to charge the LiPo battery pack or use the AC adapter.
1. AC adapter 2. LiPo Charger 3. LiPo battery pack 4. Charging connection
1. Insert the output plug of the AC adapter into the input socket (5) of the charger.
2. The red "POWER" LED will light up.
3. Connect the charging socket of the charger (4) to the charging plug of the battery. The
"STATUS" LED will light on red continiously, which shows charging is in progress.
4. When fully charged, the "STATUS" LED changes it's colour to constant green.
5. Unplug all connections in opposite order as above.
Fig. (2): Charging the LiPo battery pack
5. Input socket
8
micro
light light light light
indoor