CGS Instruments SAM-1000_DP2 Bedienungsanleitung Seite 75

7 Profibus configuration
The controller of the SAM-1000_DP2 consists of an WAGO controller with the CPU PFC200 . The
Profi bus interface ist confi gured as a slave .
There has to be set the bus address before the gas connection module SAM-1000_DP2 is
connected with the Profi bus . This could be done at the touch panel on the parameter
screen . Otherwise there can be a double addressing on the Profi bus .
There have to be used the GSD-File „A206_V10 .GSx" for confi guration in DP master . The following
modules have to be set up with the GSD-File . The order and size of the modules must be kept for a
correct function .
7.1 Module overview
7.1.1 Process image,PROFIBUS input interface
Offset Data type
I0 .0 Bool
I0 . 1 Bool
I0 .2 Bool
I0 .3 Bool
I0 .4 Bool
I0 .5 Bool
I0 .6 Bool
I0 .7 Bool
I1 .0 Bool
I1 . 1 Bool
I1 .2 Bool
I1 .3 Bool
I1 .4 Bool
I1 .5 Bool
I1 .6 Bool
I1 .7 Bool
I2 .0 Bool
I2 . 1 Bool
I2 .2 Bool
I2 .3 Bool
I2 .4 Bool
I2 .5 Bool
I2 .6 Bool
I2 .7 Bool
I3 .0 Bool
I3 . 1 Bool
I3 .2 Bool
I3 .3 Bool
Product:
SAM-1000_DP2
Assignment
Sample gas pressure low (1=fault)
Fast purge fl ow low (1=fault)
Fuse control (1=fault)
Feedback sample gas valve open AP1
Feedback bypass valve open AP1
Feedback sample gas valve open AP2
Feedback bypass valve open AP2
Feedback sample gas valve open AP3
Feedback bypass valve open AP3
Feedback sample gas valve open AP4
Feedback bypass valve open AP4
Feedback sample gas valve open AP5
Feedback bypass valve open AP5
Feedback sample gas valve open AP6
Feedback bypass valve open AP6
Feedback sample gas valve open AP7
Feedback bypass valve open AP7
Feedback sample gas valve open AP8
Feedback bypass valve open AP8
Mode 0 = Local, 1 = DCS
Revision 1 . 1 – Issue June 2016
E
75/94