CGS Instruments SAM-1000_DP2 Bedienungsanleitung Seite 69

Figure 6-5 Params
The sample gas pressure monitoring of SAM-1000_DP2 takes place by an analog measurement . The
parameter settings of this measurement are done on the „params" screen .
Pressure SAM
„min . pressure" by falling below this value I0 .0 „sample gas pressure low" is set to "0"
(fault state)
„20 mA" upper limit for scaling the analog value of pressure transmitter
„4 mA" lower limit for scaling the analog value of pressure transmitter
Product:
SAM-1000_DP2 Revision 1.1 – Issue June 2016
E
69/94