Cameo CLPSTMINICOB30W Bedienungsanleitung Seite 8

OPERATION:
STATIC COLOUR
Press the MODE button repeatedly until "C000" appears in the display.
Press ENTER and then use the UP and DOWN buttons to select the desired
colour or the stroboscopic effect ("C1" = red, "C2" = green, "C3" = blue,
"CF" = stroboscopic effect). The last two numerals stand for the brightness
(00 - 99) and, in "CF" mode, for the stroboscope speed. For example: If you
set C1, C2, and C3 to "00", all LEDs in the light are off (blackout). If you set
C1 to "99" and C2 and C3 to "00", then the light shines 100% red.
COLOUR CHANGE
Press the MODE button repeatedly until "JU00" appears in the display. Now
the light is in colour change mode. Afterwards, press ENTER and then use
the UP and DOWN buttons to select the function 7 colours "JU00" or stro-
boscope "JF00". To set the colour change and stroboscope rate (00 - 99),
press ENTER again and then use the UP and DOWN buttons to change the
values. To confirm, press ENTER again.
Note: Both functions can also be used simultaneously.
7 COLOURS
Rate 00 - 99
STROBE
Rate 00 - 99
8