Working Advice - Bosch PTK 14 E Originalbetriebsanleitung

OBJ_BUCH-109-003.book Page 16 Thursday, August 12, 2010 8:13 AM
16 | English
Hammer-force Preselection
With the thumbwheel for hammer-force prese-
lection 2, it is possible to preselect the required
hammer force in steps.
The required hammer force depends on the
length of the staples or nails, and on the
strength of the material. The optimal hammer-
force setting is best determined through practi-
cal testing.
The data in the following table are recommend-
ed values.
When operating with two staples (Duotac func-
tion), the hammer-force preselection must be
set approx. one level higher with the thum-
bwheel 2.
Structural
Material
mm
Hardwood 6
(Beech) 8
10
12
14
–
Softwood 6
(Pine) 8
10
12
14
–
Particle Board 6
8
10
12
14
–
1 609 929 V25 | (12.8.10)
Structural
Material
Wood core
plywood
Duotac-automatic
With the Duotac-automatic function, two sta-
ples are shot at the same time. Shooting two
staples at the same time prevents tearing out,
Position of
e.g., of thin fabrics or foils. The Duatac-function
Thumbwheel
is not possible when working with nails.
2
mm
To shoot two staples at the same time, push the
selector switch for Duatac-automatic 8 upward.
To shoot one stapel or one nail, push the selec-
– 3 4
tor switch for Duatac-automatic 8 downward.
– 3– 4 4
– 4 5

Working Advice

– 4 5
– 4– 5 5–6
14 6 –
– 1 2
– 2 2–3
Avoid blank shots in order to reduce the wear of
– 2–3 3
the impact striker.
– 3 3– 4
The machine is designed only for intermittent
– 3 4
operation and will warm up with continuous
14 3 –
use. The tacking force is reduced as a result of
heating up. Therefore, allow the machine to cool
off after 15 minutes (maximum) of continuous
– 2–3 4
– 3–4 4 operation.
– 3– 4 4
Stapler Plate (see figure B)
– 4 5
– 4 5–6 With the stapler plate 13, materials with a thick-
ness of up to 8 mm, such as notepads, seminary
14 4 –
paperwork, thin-walled pressboard or fabrics,
can be stapled.
Depending on the click-on position of the sta-
pler plate 13, the stapler tips are bent toward
the inside or outside.
mm mm
6 –
8 –
10 –
12 –
14 –
– 14
This machine is not suitable for working
with 19 mm staples. Therefore, do not use
the machine to fasten ceiling panelling with
profiled wood or grooves.
Position of
Thumbwheel
2
2 4
3 4
3 4–5
3–4 5
3–4 5
4 –
Bosch Power Tools