Declaration Of Conformity; Starting Operation - Bosch PTK 14 E Originalbetriebsanleitung

OBJ_BUCH-109-003.book Page 15 Thursday, August 12, 2010 8:13 AM
The vibration emission level given in this infor-
mation sheet has been measured in accordance
with a standardised test given in EN 60745 and
may be used to compare one tool with another.
It may be used for a preliminary assessment of
exposure.
The declared vibration emission level repre-
sents the main applications of the tool. However
if the tool is used for different applications, with
different accessories or poorly maintained, the
vibration emission may differ. This may signifi-
cantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the to-
tal working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 2006/42/EC.
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
12.08.2010
Bosch Power Tools
Assembly
Loading the Magazine (see figure A)
Before any work on the machine itself, pull
the mains plug.
Use only original Bosch accessories. The
precision components of the tacker, such as
magazine, striker and impact channel, are
adapted for Bosch staples, nails or pins. Oth-
er manufacturers use different steel qualities
and measures.
Press on both sides of the magazine slider 3
and pull out the magazine 11.
Insert the staple strip 10 or the nail strip 9.
Hold the tacker at a slight angle when insert-
ing the nail strip 9, so that the nails face
against the sidewall.
Slide in the magazine 11 until the closure on
the magazine slider 3 engages.
Operation

Starting Operation

Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V
can also be operated with 220 V.
Switching On and Off
At first, firmly place the tacker head 7 against
the workpiece until it is pushed in a few millim-
eters. Afterwards, briefly press the trigger 1
and then release again.
The trigger lock, which is connected with the
movable tacker head 7, prevents unintentional
shot actuation when the trigger 1 is inadvertent-
ly pressed.
For rapid working, keep the trigger 1 pressed.
Position the machine and press the tacker head
7 firmly against the workpiece until the shot is
actuated. After the shot, move the tacker to the
next location and press the tacker head 7 firmly
onto the workpiece again.
1 609 929 V25 | (12.8.10)
English | 15