Sharp GF-9500H Serviceanleitung Seite 2

Power source:
AC 1IOV
50/60Hz
DC 15V (UWSUM-I,
D type x 10, or external 15V DC)
Output power:
GF-9500H
PMPO; 36W (18W + 18W)
(AC operation)
MPO; 30W (15W + 15W)
(AC operation)
RMS,• 15W (7.5W + 7.5W)
(DC operation, DIN 45 324)
(DIN 45 324)
MPO; 20W (low
(AC operation)
RMS; 15W (7.5W + 7.5W)
(DC operation)
GF-9500E
MPO; 30W (15W + 15W)
(AC operation)
RMS; 15W (7.5W + 7.5W)
(DC operation, 10% distortion)
Semiconductors:
15 tcs
51 transistors
40 diodes
9 LEDs
Dimensions: Width;
670mm
Depth ; 125mm
Height; 225mrn
Weight:
6.4kg (14 lbs.) without batteries
TAPE RECORDER
Tape:
Compact cassette tape
Frequency response:
40Hz — 14,000Hz (normal tape)
40Hz — 16,000Hz (Cru
40Hz — 17,000Hz (metal tape)
Before operating the unit on mains, check the preset voltage.
If the voltage is different from your local voltage, adjust the
voltage as follows: Slide the AC power supply socket cover by
a little loosing screw to the visible indication
your local voltage. See Figure 2—1.
I) Turn the drum fully clockwise and stretch its cord cover
the parts in the numericalorder —asshown in Figure 2—2.
2) Turn the tuning control shaft fully counterclockwise,and
fix it with the pointer aligned with the zero (O) point on
the frame. See Figure 2—3.
meter band
K-SW
short wove
M -MW
medium wave
L -LW
long wove
frequency mod
channel
Figure 2-3
FOR A COMPLETE DESCRIPTION
UNIT, PLEASE REFER
SPECIFICATIONS
120V and 220V 240V,
R 20, HP-2 or
+ IOW)
(26-3/8")
(4-15/16")
(8-7/8")
tape)
VOLTAGE
of the side of
DIAL CORD
49 m
Pulley
6.0 6.5
54 60
150 170
92
r'O„point
OF THE OPERATION
TO THE OPERATION MANUAL.
Signal (noise ratio:
Wow and flutter:
GF-9500H
GF-9500E
Input sensitivity and impedance:
Output level and loaded impedance:
Headphones;
External speakers;
Record/playback
RADIO
Frequency range:
SPEAKERS
Speakers:
Impedance:
Maximum power handling
GF-9500H
GF-9500E
Specifications for this model are subject to change without
prior notice.
SELECTION
SCREW
2aov
Figure 2-1
STRINGING
4 Turns
Figure 2-2
-2-
OF THIS
50dB (normal tape, Dolby NR off)
60dB (metal tape, Dolby NR on)
0.06% (WRMS)
0.15% (DIN 45 511)
0.15% (CCIR)
External mic; 600 ohms
Phono; 50 kohms
Record/playback DIN socket; 0.7mV/
5.6 kohms
8 ohms — 25 ohms
3.2 ohms — 8 ohms
DIN socket;
0.65V/50 kohms
LW; 150kHz -285kHz
MW; 520kHz - 1,620kHz
SW; 5.95MHz - 18.0MHz
FM; 87.6MHz - 108MHz
16cm (6-1/2") woofer x 2
Horn type tweeter x 2
3.2 ohms
capacity:
IOW (maximum)
15W (music power)
IOW (maximum)
Acvo
SCREW
Dial
Drum
C)
438±9 mm
Pulley
Pointer