Operation With Dmx Controller; Dmx Connection; Adjusting The Dmx Operating Mode And Start Address - EuroLite LED STRIP RGB DMX512 Bedienungsanleitung

Operation with DMX Controller

To control the LEDs connected via a lighting controller with DMX512 protocol,
the controller is equipped with three DMX control channels. Several units can
be interconnected.
Channel DMX value
1 0-255
2 0-255
3 0-255

DMX Connection

For the DMX connection, 3-pin XLR and RJ45 jacks are provided. Both
connectors can be used as desired. The pin configuration is printed on the
unit.
1
Connect the DMX controller to the DMX input DMX512 IN.
2
Connect the DMX output DMX512 OUT to the DMX input of the next
controller or the next DMX-controlled unit. Always connect one output
to the input of the next unit until all units are connected. Connect a
120 Ω terminating plug to the DMX output of the last DMX unit in the
chain.

Adjusting the DMX Operating Mode and Start Address

To the control the controller from a DMX lighting controller, adjust the DMX
start address for its first DMX channel. The start address is adjusted as a
binary number via the DIP switches.
1
Set DIP switch 10 to the upper position.
2
The start address is will result by addition of the values of switches 1-
9.
www.eurolite.de
Function
Red dark bright
Green dark bright
Blue dark bright
⊳ Position of switch 10 for operation
with DMX controller
⊳ Example for address 20:
switches 3 and 5 in the lower position
17