Setup; Connecting The Leds And The Power Supply - EuroLite LED STRIP RGB DMX512 Bedienungsanleitung

4

SETUP

1
1
DIP switches 1-9 adjust the DMX start address or the built-in control
programs.
DIP switch 10 determines the operating mode: up = DMX operation,
down = operating without DMX controller
2 DMX input and output via RJ45 jacks
3
DMX input and output via 3-pin XLR connectors
4 Terminals for the operating voltage
5 Terminals for the LEDs

Connecting the LEDs and the Power Supply

1
Fix the control unit at a suitable place with two screws.
2
Connect the LEDs to the terminals OUTPUT. The load by the LEDs
must not exceed 4 A per channel. The total load must not exceed 12
A; otherwise the control unit will be damaged.
CH1 = negative pole for the red LEDs
CH2 = negative pole for the green LEDs
CH3 = negative pole for the blue LEDs
COM + = common positive pole
3
For power supply, a matching power supply unit will be required (min.
12 V, max. 24 V). The power supply unit must provide the current
required for operating the LEDs plus a supply current of 100 mA for
the controller. Connect the power supply unit to the positive and
negative INPUT terminals.
To facilitate handling, the terminals can be removed from their plug-in
connections on the unit and replaced after connection.
www.eurolite.de
2 3
(min. 12 V, max. 24 V)
15
4 5